If you’re just doing a light debris vacuum, you can keep it on the “Filter” setting. What setting do you put your pool filter on when vacuuming? Looking for more help with your pool vacuum cleaner? Here are some common questions and answers. Frequently Asked Questions About Vacuuming a Pool You don’t have to dread the vac head! When it’s time to vacuum your pool-whether you’re just the hands-on type or waging war on invading algae-you can get the job done by hand with a little preparation, a lot of elbow grease, and a healthy dollop of patience. This will help keep it in top working condition and avoid unnecessary wear and corrosion. Rinse all your equipment with freshwater, dry it, and return it to storage.Once you’ve topped off your water, test your pool water, and adjust your alkalinity, pH, and chlorine as necessary.If you used the “Waste” setting to vacuum the pool, make sure you switch the valve back to the “Filter” setting and keep adding fresh water to your pool until the water level is restored.
#POOL VACUUM FULL#
Here’s our full guide on cleaning your pool filter after you’re done vacuuming.
Remove the vacuum head from the telescoping pole, and drain any water still in the vacuum hose.Once you’ve finished vacuuming your entire pool, it’s time to clean up and get back to swimming. Disconnect The Vacuum and Perform a Final Clean If the pressure rises above the levels recommended by the manufacturer, take a break, and backwash your filter. Also, be sure to monitor your pool filter’s pressure gauge as you vacuum.
If the vac head becomes stuck, switch off the pump for a second to break the vacuum force and set it free. If the water does become cloudy, give it a couple of hours to resettle, then come back and vacuum again, repeating as necessary. Rushing will just kick up debris, which will reduce visibility and take hours to settle down again. Make sure your strokes overlap slightly to avoid leaving any debris behind. Use long, slow, sweeping strokes to clean. If you have a round pool, just start at one side and move left or right across the floor. Start at the shallow end (if you have one) and move toward the deep end of the pool. Now that you’ve built a powerful siphon using your filter system, you can vacuum the floor of your pool. If the hose is slippery, use a hose clamp to keep it in place. Attach one end of the hose to the vac head.
Attach the vacuum head to the open end of the telescopic pole. Attach Vacuum Head and Hose to the Telescopic Poleįirst, ensure the pump and filter are running. Use a garden hose to add fresh water while you’re vacuuming. Your pool water level will drop while you vacuum. If you have a cartridge filter, just remove the drain plug and attach a backwash hose.
This will bypass your filter and send the dirty water out through the waste port. IMPORTANT: If you’re dealing with algae or cloudy water, change your filter valve settings to the waste setting if you have a multiport valve or push/pull valve. Here’s our full guide on cleaning every type of filter. If you have a cartridge filter, make sure the cartridges inside are cleaned and ready to go. or sand filter and the pressure is high, backwash it. You also want to check that you’re running at a good starting pressure.
#POOL VACUUM MANUAL#
A Step-By-Step Guide to Installing and Cleaning Your Pool with a Manual Pool Vacuumīefore you get started, make sure the pool pump and filter are running.
0 kommentar(er)
